DIR-620 Wireless N300 Router with 3G/CDMA/LTE Support
and USB Port
User Manual
Configuring via Web-based Interface
In the IPv6 DHCP server section, you can enable the DHCPv6 server of the router and select its
operating mode.
Figure 111. The section for configuring the DHCPv6 server.
Parameter Description
Enable DHCPv6 Server
Select the checkbox to enable the DHCPv6 server of the router.
When the checkbox is selected, the State mode drop-down list and
the Leased Time field are displayed on the page.
DHCP PD
Select the checkbox to activate the Prefix Delegation function. When
the checkbox is selected, the router requests a prefix to configure
IPv6 addresses for clients of the LAN from a delegating router.
State mode
Select an operating mode of the DHCPv6 server from the drop-down
list.
Stateless: clients themselves configure IPv6 addresses using the
prefix.
Stateful: clients receive IPv6 addresses from the range specified in
the Start interface IP and End interface IP fields.
Start interface IP
The start IPv6 address of the address pool used by the DHCPv6
server to distribute addresses to clients.
End interface IP
The end IPv6 address of the address pool used by the DHCPv6
server to distribute addresses to clients.
Leased Time
The lifetime of IPv6 addresses leased by the DHCPv6 server. The
field is available for editing, if the DHCP PD checkbox is not
selected.
When all needed settings are configured, click the Apply button.
Page 133 of 225
To Next Page
Loading...
