DIR-632 Multifunction Wireless Router Supporting WiMAX,
3G GSM/CDMA with Built-in 8-port Switch
User Manual
Installation and Connection
To restore the factory default settings, insert a small paperclip into the hole of the button (with the
router powered on), push, and hold for 10 seconds. Then remove the paperclip. All LEDs of the
router should turn off and then turn on again.
Wait for about 30 seconds. Now you can access the web-based interface of the router using the
default IP address, username and password.
If you fail to restore the factory defaults via the method described above, use the emergency reset
method.
1. Power off the device.
2. Insert a small paperclip into the hole of the RESET button and push.
3. Power on the device keeping the button pushed.
4. After 5 seconds, release the button.
!
When you keep the button pushed for more than 8 seconds, the router switches to crash
recovery mode. To restore normal operation of the router, please, contact the Technical
Support Service.
When you have configured all needed settings, click the Logout line.
Page 37 of 197
To Next Page
Loading...
