D-Link DIR-810L - Advanced Network Settings

90D-Link DIR-810L User Manual
Section 3 - Conguration
To use the Universal Plug and Play (UPnP
™
) feature check
the Enable UPnp box. UPnP provides compatibility with
networking equipment, software and peripherals.
Checking this box will allow the DIR-810L to respond
to pings. Unchecking the box may provide some extra
security from hackers.
Allow All is the default selection from the drop-down
menu when you check Enable WAN Ping Respond, allowing
you to apply the inbound Filter to the WAN Ping. (Refer to
page 83 for more information about inbound lters.)
You may set the port speed of the Internet port to 10Mbps,
100Mbps, or Auto 10/100Mbps (recommended).
Check the box to allow multicast trac to pass through
the router from the Internet (IPv4).
Check the box to allow multicast trac to pass through
the router from the Internet (IPv6).
Enable UPnP:
Enable WAN Ping
Respond:
WAN Ping Inbound
Filter:
WAN Port Speed:
Enable IPV4
Multicast Streams:
Enable IPV6
Multicast Streams:
Advanced Network Settings