12D-Link DIR-879 User Manual
Section 2 - Choosing an Operation Mode
Access Point
Create a Wireless Network using Ethernet
The DIR-879 operates as an Access Point when the mode switch is in the Extender position and an Ethernet cable is
connected from an Ethernet Port to an uplink network.
Use this mode for:
• Extending your current network.
• Providing better signal for parts of your home or oce that may have poor reception.
• Bringing Wi-Fi to an area it doesn't currently reach.
• Adding Wi-Fi to a wired network.
• Maximizing bandwidth.
• Creating a Wi-Fi pocket away from your existing network.
Note: Extending a network to a desired location via Ethernet may require additional cable. The maximum length of Category
5/5E cables is limited to 100 meters (330 feet). Use a Gigabit-capable Ethernet connection where possible to ensure the best
networking experience.
To use your DIR-879 as an Access Point, refer to Installation - Access Point on page 37.
Broadband
Connection Device
(e.g. DSL/Cable Modem)
Existing
Network
Internet Wired and Wireless DevicesDIR-879
To Next Page
Loading...
