D-Link DIR-879 - Page 44

40D-Link DIR-879 User Manual
Section 4 - Installation - Access Point
4. Connect an Ethernet cable from your uplink network to the INTERNET port on the back of the DIR-879, press the power
button, and wait approximately one minute until the LED indicator on the front of the device changes from orange to
solid white.
5. Connect wired devices to the LAN ports on your DIR-879. Connect wireless devices to the Wi-Fi network printed on
the included Wi-Fi Conguration Card. You can also nd the Wi-Fi network names and passwords printed on the label
attached to the bottom your DIR-879.
DIR-879
Existing RouterInternet Broadband Connection Device
(e.g. DSL/Cable Modem)
Wi-Fi Conguration Note
DIR-879
Existing RouterInternet Broadband Connection Device
(e.g. DSL/Cable Modem)
Congratulations, your device has been successfully congured!
Refer to Conguration - Extender Mode on page 97 for information on changing the default wireless network names
or passwords.