D-Link DIR-880L - Page 88

84D-Link DIR-880L User Manual
Section 3 - Conguration
Enter the IP Address as 192.168.0.XX.
Enter the Subnet Mask as 255.255.255.0.
Enter the Default Gateway as the LAN IP address of your router.*
Enter the Primary DNS Server IP address. The IP address of your
router is recommended, or you could use the IP address assigned
by your ISP.
Enter the Secondary DNS Server IP address assigned by your ISP,
or you can leave it blank.
Maximum Transmission Unit - by default this eld will be set to
Auto. Select Manual if you need to change the MTU for optimal
performance with your ISP.
Click Save when you are done.
*Note: For information about checking your IP address, refer to
"Networking Basics" on page 167.
IP Address:
Subnet Mask:
Default
Gateway:
Primary DNS
Server:
Secondary DNS
Server:
MTU:
Static IP
The factory default IP address for the DIR-880L in Bridge Mode is 192.168.0.50. If you select Static IP, assign an IP Address as 192.168.0.XX, and a
Subnet Mask as 255.255.255.0.