D-Link DIR-880L - Page 89

85D-Link DIR-880L User Manual
Section 3 - Conguration
Wireless (Bridge Mode)
Enter the Network Name (SSID) of the network you are trying to
connect to.
Choose None, WEP, or WPA/WPA2-Personal depending on the
security used by the network you are trying to connect to.
Select the length of the password used by the network you are trying
to connect to (for WEP only).
Enter the existing network's wireless Password. (for WEP and WPA/
WPA2-Personal only)
Click Save when you are done.
Wireless
Network Name:
Security:
Password
Length:
Password:
From the Settings menu, click Wireless to see the wireless conguration options. In Bridge Mode, the wireless function
allows you to connect to an existing wireless network. You can either enter the settings manually, or click Scan to search
for visible wireless networks. (See instructions below.)
To scan for available wireless networks, click Scan, then click on the wireless network
you want to connect to. You can see the wireless signal strength of each network,
and the padlock icon means that a password is required to connect to that network.
Click Select to nalize your choice, then Save when you are done.