D-Link DNS-323 - Network Storage Enclosure NAS Server User Manual

10D-Link DNS-323 User Manual
Section 2 - Installation
Installation
1. Access the drive bays by sliding the faceplate
up until it unlatches from the device.
2. Once the faceplate is unlatched, pull it off the
device, exposing the drive bays.
This section provides unpacking and installation information for the DNS-323. Open the shipping carton for the
DNS-323 and carefully unpack its contents. To install the DNS-323 on your local network, refer to the steps below:
Hardware Setup

D-Link DNS-323 - Network Storage Enclosure NAS Server Specifications

General

Device Type	NAS server
Number of Bays	2
Weight	1.5 kg
Network Architecture	Gigabit Ethernet
Supported Drive Types	3.5" SATA I/II
RAID Levels	JBOD, RAID 0, RAID 1
Supported Protocols	HTTP, FTP, SMB, NFS
Max Internal Capacity	4 TB (2 x 2 TB)
Processor	Marvell 88F5182
Memory	64 MB
Power Consumption	25 W (operational)
Operating Temperature	0 to 40°C (32 to 104°F)
Interfaces	1 x 10/100/1000 Gigabit Ethernet, 1 x USB 2.0
Data Transfer Rate	1 Gbps