D-Link DPR-1020 Quick Install Guide

5
HARDWARE INSTALLATION
WARNING: There may be conguration problems if the Print Server is turned on
without rst establishing a network connection.
Follow the steps below to avoid any complications during the hardware
installation:
1. Conrm that the printer you will use to connect to the DPR-1020 is operating
correctly.
2. When you have conrmed that the printer is operating correctly, switch its power
OFF.
3. Conrm that your network is operating normally.
4. Using a CAT 5 Ethernet cable, connect the DPR-1020 Ethernet Port (labelled
LAN) to the network.
5. While the printer is turned OFF, connect the USB printer cable to the printer and
then to the USB port on the Print Server.
6. Switch on the printer.
7. Insert the power adapter’s output plug into the DC 5V power socket on the rear
panel of the Print Server.
8. Connect the other end of the power adapter into a power outlet. This will supply
power to the Print Server. The blue LED on the Print

D-Link DPR-1020 Specifications

General

Networking standards	IEEE 802.3, IEEE 802.3u
Network connection type	Ethernet LAN
Dimensions (WxDxH)	67 x 106 x 25 mm
Power requirements	5.0V DC/2.5A
Compatible operating systems	Windows Vista/XP/2000/NT4/ME/98SE/95 Apple Mac OS 9.x - MAC OS X 10.4.x Linux UNIX lpr/lpd (HP-UX, SunOS, Solaris, SCO, UnixWare, IBM AIX) NetWare 5.x
DC-in jack	Yes
USB 2.0 ports quantity	1
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C
Certification	FCC Class B, CE, C-Tick, IC, CSA
Package depth	225 mm
Package width	150 mm
Package height	75 mm
Package weight	520 g

Weight and Dimensions

Depth	106 mm
Width	67 mm
Height	25 mm
Weight	77 g