55D-Link DSL-3785 User Manual
Section 4 - Conguration
If you enabled IP ltering, click to create a new IP ltering rule.
Create New Rule
Name: Create a name for the rule.
Protocol: Select the protocol type: , UDP, TCP, or ICMP.
Source IP Address: Select IP address, Single IP, or . If
you selected Single IP or , enter the IP
address into the and To elds.
Destination IP
Address:
Select the destination to apply the rule to: PVC1, PTM, or .
Select IP address, Single IP, or . If
you selected Single IP or , enter the IP
address into the and To elds.
If you selected PTM or as the , select the Service Number.
Service Number: Select the Service Number from the drop down menu.
If you selected UDP or TCP as the Protocol above, you may lter , a Single Port,
or Specify a Port Range.
Schedule: Use the drop-down menu to select the time schedule that the rule will
be enabled on. The schedule may be set to , or you can create
your own schedules in the Schedules section. Refer to Schedule on
page 62 for more information.
Click when you are done.
IP Filter (continued)
To Next Page
Loading...
