10/100 Fast Ethernet Switch Manual
1
1
0 FEATURES
♦ 24 UTP ports all come with NWay auto-negotiation and operate at
10/100 Mbps for connection to servers and hubs. All ports can
auto-negotiate for full- or half-duplex operation.
♦ All ports support auto MDI/MDIX, so there is no need to use cross-
over cables When connecting to another switch.
♦ Store-and-forward switching scheme capability to support rate
adaptation and ensure data integrity.
♦ Auto-polarity detection for correction of incorrect polarity on the
receive twisted pair at each port.
♦ Data forwarding rate 148,800 pps per port at 100% of wire-speed
for 100Mbps speed.
♦ Data forwarding rate 14,880 pps per port at 100% of wire-speed
for 10Mbps speed.
♦ Data filtering rate eliminates all error packets, runts, etc. at
148,800 pps per port at 100% of wire-speed for 100Mbps speed.
♦ Data filtering rate eliminates all error packets, runts, etc. at
14,880 pps per port at 100% of wire-speed for 10Mbps speed.
♦ Up to 4K unicast address entities per device, self-learning, and
table aging.
♦ Embedded 1.5Mbits packet buffer.
♦ All 24 UTP ports support IEEE802.3x flow control for full-duplex
and backpressure flow control for half-duplex.
♦ Optional two-port Fiber module (SC type connector) in the front
panel for length extension. These two ports operate at 100M full-
duplex. Please see Chapter Two for additional information about
module settings.
To Next Page
Loading...
Need help?
General
