D-Link DWS-3160-24TC - Page 404

DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide
399
associate with the AP using the SSID in the previous field.
Client QoS Bandwidth
Limit Down
Enter the maximum allowed transmission rate from the AP to the wireless client in
bits per second.
Client QoS Bandwidth
Limit Up
Enter the maximum allowed client transmission rate to the AP in bits per second.
Client QoS Access
Control Down
Use the drop-down menu to select the name of the access list applied to traffic in
the outbound (down) direction.
Client QoS Access
Control Up
Use the drop-down menu to select the name of the access list applied to traffic in
the inbound (up) direction.
Client QoS Diffserv
Policy Down
Use the drop-down menu to select the name of the DiffServ policy applied to traffic
from the AP in the outbound (down) direction.
Client QoS Diffserv
Policy Up
Use the drop-down menu to select the name of the DiffServ policy applied to traffic
from the AP in the inbound (up) direction.
Click the <<Back button to discard the changes made and return to the previous window.
Click the Apply button to accept the changes made.
Click the Clear button to discard the changes made and return to the default settings.
After clicking the Valid AP tab, the following page will appear:
Figure 3-7 Basic Setup Valid AP window
The fields that can be configured are described below:
Parameter Description
MAC Address
Enter the MAC address of the AP.
Location
Enter a location to help identify the AP.
Click the Add button to add a new entry based on the information entered.
Tick one or more MAC addresses, select an AP profile from the drop-down menu and click the Change Profile
button to change the profile assigned to the selected AP or APs.
Tick one or more MAC addresses and click the Delete button to remove the entry.
Click the Delete All button to remove all the entries.
Click the MAC Address hyperlink to see more Valid AP configuration.
Click the Profile hyperlink to go to the AP Profiles window.