D-Link DWS-3160-24TC - Page 455

DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide
450
matches the rule’s criteria.
Match Every Use the drop-down menu to select True or False. True means that all packets will
match the selected MAC ACL and Rule, and will be either permitted or denied.
When True is selected, the option of configuring other match criteria will not be
offered since all packets match the rule. To configure specific match criteria for the
rule, select False to configure the other match criteria.
CoS
Enter the 802.1p user priority to compare against an Ethernet frame.
Destination BPDU
Tick the check box to use multicast address 01:80:C2:00:00:00 as destination MAC
and mask is FF:FF:FF:00:00:00.
Destination MAC
Enter a MAC address and an Ethernet frame’s destination MAC address must
match the address.
Destination MAC Mask
Enter the mask of the destination MAC.
Ethertype Key
Use the drop-down menu to select EtherType. A packet’s EtherType must match
the selected EtherType. When selecting User Value, the Ethertype Value field
appears. Enter a custom value in the field.
Source MAC
Enter a MAC address and an Ethernet frame’s source MAC address must match
the address.
Source MAC Mask
Enter the mask of the source MAC.
VLAN
Enter an ID of the VLAN. A packet’s VLAN ID Must match the entered ID.
Click the Create Rule button to add a new rule.
Click the Cancel button to discard the configuration.
After clicking the Rule ID hyperlink or the Edit button, the following page appears:
Figure 4-19 MAC Access Control Lists – Edit Rule window
The fields that can be configured are described below:
Parameter Description
Action
Tick the check box and use the drop-down menu to select the ACL forwarding
action.
Match Every Tick the check box and use the drop-down menu to select True or False. True
means that all packets will match the selected MAC ACL and Rule, and will be
either permitted or denied. When True is selected, the option of configuring other
match criteria will not be offered since all packets match the rule. To configure
specific match criteria for the rule, select False to configure the other match criteria.