34D-Link DRA-2060 User Manual
Section 3 - Conguration
IPv6 - Autoconguration (SLAAC/DHCPv6)
is
Select Autoconfiguration (SLAAC/DHCPv6) to have the
DRA-2060 automatically receive an IPv6 address from the
uplink router.
Obtain a DNS server
address automatically
You can select to obtain IPv6 DNS server information
automatically, or you can select to congure DNS servers
manually by selecting next to the option Use the following
DNS address.
Primary DNS Server For manual settings, enter the primary IPv6 DNS server address.
Secondary DNS Server For manual settings, enter the secondary IPv6 DNS server
address. This is optional but will provide backup if the primary
server fails.
IPv6 - Static IPv6
is
Select Static IPv6 to manually assign an IP address to the
DRA-2060.
IPv6 Address Enter the IPv6 address that you want to assign to the extended
network AP. This address should be outside of the uplink
router’s DHCP address pool.
Subnet Prex Length Enter the length of the IPv6 subnet prex.
Default Gateway Enter the default gateway.
Primary DNS Server Enter the primary IPv6 DNS server address.
Secondary DNS Server Enter the secondary IPv6 DNS server address. This is optional
but will provide backup if the primary server fails.
IPv6 - Local Connectivity Only
is
Select Local Connectivity Only to set an IPv6 address only
for the local network.
LAN IPv6 Link-Local
Address
The link-local address of the DRA-2060.
To Next Page
Loading...
Need help?
General
