D-Link EXO Series User Manual

82D-Link EXO Series Router User Manual
Section 3 - Conguration
DCHP Server
Status Enable or disable the DHCP server.
DHC IP Address Range Enter the starting and ending IP addresses for the DHCP
server's IP assignment. Note: If you statically assign IP addresses
to your computers or devices, make sure the IP addresses are
outside of this range or you may have an IP conict.
DHCP Lease Time Enter the length of time for the IP address lease in minutes.
Always Broadcast Enable this feature to broadcast your network's DHCP server
to LAN/WLAN clients.
Advanced Settings
WAN Port Speed You may set the port speed of the Internet port to 10 Mbps,
100 Mbps, 1000 Mbps, or Auto (recommended).
UPnP Enable or disable Universal Plug and Play (UPnP). UPnP
provides compatibility with networking equipment, software,
and peripherals.
IPv4 Multicast Streams
Enable to allow IPv4 multicast trac to pass through the router
from the Internet. This is enabled by default.
IPv6 Multicast Streams
Enable to allow IPv6 multicast trac to pass through the router
from the Internet. This is enabled by default.

D-Link EXO Series Specifications

General

Wi-Fi Standard	Wi-Fi 6 (802.11ax)
MU-MIMO	Yes
Smart Connect	Yes
Beamforming	Yes
OFDMA	Yes
Security	WPA3
Frequency Bands	Dual-band
Ethernet Ports	Gigabit Ethernet
USB Ports	1 x USB 3.0
Maximum Speed	AX1800