D-Link GO-SW-16G

Connect to Hub or Switch
These connections can be accomplished in a number of ways using a
standard Ethernet cable.
• A 10BASE-T hub or switch can be connected to the Switch via a
twisted-pair Category 3, 4, 5, or 5e UTP/STP cable.
• A 100BASE-T hub or switch can be connected to the Switch via
a twisted -pair Category 5 or better UTP/STP cable.
• A 1000BASE-T switch can be connected to the Switch via a
twisted -pair Category 5 or better UTP/STP cable.
Switch connected to a port on a hub or switch using either a straight or crossover cable–
any standard Ethernet cable is fine
20