D-Link SECURICAM Network DCS-900W

27
Single Camera Installation
If you are installing a single camera on your network the installation is an easy 4–step
procedure:
1) Identify Your Camera on the Network
2) Assign a Local IP Address for Your Camera
3) Determine Your Router’s WAN IP Address (Enable Remote Viewing)
4) Open Virtual Server Ports for Your Router (Enable Remote Viewing)
Multiple Camera Installation
If you are installing multiple cameras on your network, the installation is an easy 5-
step procedure:
1) Identify Your Camera on the Network
2) Assign a Local IP Address for Your Camera
3) Open a Second Port on the Camera
4) Determine Your Router’s WAN IP Address (Enable Remote Viewing)
5) Open Virtual Server Ports for Your Router (Enable Remote Viewing)
DCS-900W Configuration (continued)
Installing the DCS-900W Behind a Router