D-Link Wireless N900

59D-Link DIR-855L User Manual
Section 3 - Conguration
Static IPv6 Address Connection
Use Static IPv6 Address Connection when your ISP provides you with a set IPv6 addresses that does not change. The IPv6 information is manually
entered in your IPv6 conguration settings. You must enter the IPv6 address, Subnet Prex Length, Default Gateway, Primary DNS Server and
Secondary DNS Server. Your ISP provides you with all of this information.
Use Link-Local
Address:
IPv6 Address:
Subnet Prex
Length:
Default Gateway:
Primary DNS
Address:
Secondary DNS
Address:
LAN IPv6 Address:
The Link-local address is used by nodes and routers when
communicating with neighboring nodes on the same link.
This mode enables IPv6-capable devices to communicate
with each other on the LAN side.
Enter the WAN IPv6 address for the router here.
Enter the WAN subnet prex length value used here.
Enter the WAN default gateway IPv6 address used here.
Enter the WAN primary DNS Server address used here.
Enter the WAN secondary DNS Server address used here.
These are the settings of the LAN (Local Area Network)
IPv6 interface for the router. The router’s LAN IPv6 Address
conguration is based on the IPv6 address and subnet
assigned by your ISP. (A subnet with prex /64 is supported
in LAN.)