3 | Cover and SCreen
To clean the exterior of Bob, simply wipe it with a damp cloth
Depending on the amount of soil on your Bob.
Please do not use any scouring agents, chemical solvents or strong detergents as this
could damage the coating of Bob.
To prevent water from getting into the electronic components, screen, buttons or door lock
system,do not use a cleaning spray.
2 | heatinG eleMentS
The heating disk must be cleaned thoroughly to avoid clogging and
reduced rinsing performance.
Once per month or every 30 cycles
To access the heating disc, please remove the 3 filters.
Then remove the protection part of the heating disc and clean it.
You then have access to the heating disc, clean it with a non-
abrasive sponge in order to avoid damaging (scratching) the non-
stick coating.
Put the protection part back in place.
Then reinsert the 3 filters.
4 | Spray arM
If you encounter problems with the spray arm and have observed that it no longer turns, it may
be a nozzle blockage that prevents it from turning. In this case, please follow the instructions
below to clean the spray arm.
To remove the spray arm, unscrew the ring at base of the
spray arm with one hand.
Wash the spray arm under running water and remove any food
residues from the spray nozzles.
Put it back in place and make sure that nothing hinders its
rotation.
1918
EN
To Next Page
Loading...