Daan Tech Bob - Pre-Wash Cycle Preparations; During the Wash Cycle; Pausing and Cancelling Cycles; Adding Items Mid-Cycle

DAILY
3 | WaSh CyCle
3.1 | How a wash cycle works
You can follow the progress of the current wash cycle on Bob’s screen
Icon of the current program
Remaining time
(minutes and seconds)
y Make sure that your dishes are positioned correctly in the basket
y Put detergent (gel or tablet or powder) inside the tank
y Close the door. Warning: the cycle cannot be initiated if the door is open or not properly closed
y Choose the most appropriate program according to your dishes and the degree of soiling
y Start the cycle on Bob’s display
y Fill the water tank until the signal sound occurs if your Bob is not connected to a water
supply
Before starting a wash cycle
Warning: Ensure that the drain hose is correctly positioned at a water drain
or a container during the entire cycle. Water is drained several times during
a cycle.
Let’s go! The cycle is running now!
y Press the central button to pause the current cycle.
y Select NO to cancel the current cycle and to launch a drain.
y You will automatically be redirected to the home screen.
Cancelling an ongoing cycle
During a wash cycle
When the timer is close to zero, the “Drying in progress” icon is displayed.
At the end of the wash cycle
At this point, the door opens automatically and remains half-open with a 10
degree angle.
Warning Please note that hot steam is released when door opens
Depending on the program, drying might take several minutes and will not
consume additional energy. The program is not completed yet; please wait
a few minutes for the drying to finish before removing your dishes.
Warning Please note that some items are very hot and could cause
skin burns if removed too soon. Daan Tech shall not be responsible
for such incidents, which occur when dishes are removed before the
offical end of the cycle.
When the program is completed, a signal sound occurs and Bob will automatically go into standby
mode.
Upon completion of the program, leave Bob’s door open (10°) to prevent unpleasant smell. This also
reduces the energy consumption in the standby mode.
Please note that some water
residue may remain on your
dishes if you do not wait for the
drying to nish.
Adding extra items during an ongoing cycle
y Press the central button to pause the current cycle.
y Open the door and pay attention to the escaping hot steam
y Place the additional item in the basket
y Close the door
y Select YES to continue the cycle
Warning: If you want to cancel a cycle or add additional items, you must press the central
button to interrupt the program.
1312
EN