Brand name Bob
Product name BOEM
Manufacturer name Daan Technologies SAS
Origin of manufacturing France (Vendée)
Number of standard place settings 2
Energy efficiency class
G
Annual energy consumption
98 kWh/year
Energy consumption for a standard cycle 0,40 kWh/cycle
Standby power consumption (door half-open) 0.5 W
Standby mode duration 5 minutes
Annual water consumption
1064 litres
produCt Sheet
This product sheet complies with the European Directive No. 1059/2010.
NOTES
A (maximum efficiency) to G (minimum efficiency)
Energy consumption of 98 kWh based on 280 standard wash cycles with cold water supply and consumption of low power
modes. The actual energy consumption may differ depending on the conditions.
Water consumption of 1064 litres a year based on 280 standard wash cycles. The actual energy consumption may differ
depending on the conditions.
A (maximum efficiency) to G (minimum efficiency)
This program is suitable for cleaning medium solid dishes. It is the most efficient program in terms of the combined
energy and water consumption for this type of dishwasher.
DISPOSAL
As a manufacturer, we commit to reduce the environmental footprint of our products. We highly recommend you to follow
the disposal guidelines applicable in your country. This will help preserving natural resources by recycling Bob in an eco-
friendly manner. Since Bob has built-in electronic parts, it shall not be disposed with household waste, and must be discarded
according to the applicable law at the time of disposal. For more information about the disposal of electronic waste, please
ask your local authorities.
Drying performance class A
Standard cleaning cycle
Eco
Duration of the standard cleaning program 180 minutes
Sound level 43 dB(A) re 1 pW
Can be used as built-in dishwasher No
Height 49 cm (19,3 in)
Width 34 cm (13,4 in)
Depth (with cables & water inlet / outlet) 49 cm (19,3 in)
Power consumption 1000 W
Voltage & Frequency 220-240V~ 50Hz
Water pressure (water inlet) 0,5-10 bar = 0,05-1 MPa
2 | repair and CuStoMer ServiCe
All components are available for 11 years from the date of purchase of the Bob. If you have a
problem with a component of your Bob, please contact the customer service department of the
shop where your Bob was purchased.
IMPORTANT: If you need to have your Bob repaired or transported, please follow the return
procedure:
1. Drain your Bob with the Drain cycle (Drain menu ) and/or unplug the Bob and turn it over a
sink to empty the remaining water in the tank
2. Clean the filters, the spray arm with clean water and the inside of the tank with a sponge
3. Seal the water inlet and outlet with absorbent paper before sending.
4. Be careful not to wrap Bob in plastic, as the electronics may be damaged by water.
5. Place Bob in his original box with the protections provided.
6. Tape the top and bottom cardboard flaps well.
2524
EN
To Previous Page
Loading...
