How to fix a Daan Tech Bob 2020 (Bob) that does not turn on?
If your Daan Tech Dishwasher, Bob, won't turn on, there are a couple of things to check. First, a fuse in your electrical system may have blown, or the circuit breaker may have tripped. Try unplugging other appliances on the same circuit and then replace the fuse or reset the breaker. Second, ensure the power cord is properly plugged into both the wall outlet and Bob itself.
What to do if the Daan Tech Bob 2020 Dishwasher (Bob) cycle does not start?
If your Daan Tech Dishwasher, Bob, cycle doesn't start, it could be due to several reasons. First, make sure a Bob cassette (empty or full) is inserted. Second, check that the door is fully closed. If the door won't close, see if something is blocking it. Third, if you're using the integrated tank mode, ensure the tank is filled until the signal sounds. If using the water supply mode, verify your installation, ensuring the tap is open and there's sufficient pressure. Finally, if the screen is frozen, wait 3 seconds for Bob to start, or try disconnecting and reconnecting Bob.
Why is water not draining out of my Daan Tech Dishwasher (Bob)?
If water isn't draining from your Daan Tech Dishwasher, Bob, the drain hose might be bent. Check the hose and secure it with 'Bob Easyfix'. Also, the water outlet under the filter could be blocked; clean the bottom of the interior and the filters.
Why is there foam inside the tank of my Daan Tech Bob 2020 (Bob)?
If you see foam forming inside the tank of your Daan Tech Dishwasher, Bob, during a cycle, it could be due to inappropriate detergent. Avoid special dishwasher detergents to prevent foaming. If foaming occurs, open the door to let the foam evaporate, then close the door and start a wash program to drain the water. Repeat if necessary. Also, some types of soil generate more foam. If there's too much foam, it can block the spray arm. Empty the basket and run an empty cycle before washing dishes again.
How to remove stains on interior surfaces of Daan Tech Dishwasher (Bob)?
If you notice stains on the interior surfaces of your Daan Tech Dishwasher, Bob, it could be limescale buildup. Run a maintenance cycle at least once every 90 cycles with a rock'n'roll cassette. If you live in an area with very hard water, run a maintenance cycle more frequently, about every 30 cycles.
Why are the dishes not clean after using Daan Tech Dishwasher (Bob)?
If your dishes aren't getting clean in your Daan Tech Dishwasher, Bob, first, ensure the dishes are correctly placed in the basket, avoiding contact between items. Second, the selected wash program might be unsuitable, so choose a more intensive program. Third, you might not be using enough detergent or the right kind; use a ‘pop cassette’ for optimal cleaning. Fourth, check if the spray arm is blocked by dishes and rearrange them so it can rotate freely. Fifth, one or more of the spray arm nozzles could be clogged; disassemble and clean the spray arm. Finally, the filters might be dirty or not correctly arranged; disassemble and clean them.
What to do if the dishes do not properly dry in Daan Tech Bob 2020 Dishwasher (Bob)?
If your dishes aren't drying properly in your Daan Tech Dishwasher, Bob, make sure they are correctly arranged in the basket. Also, you might not be using enough detergent or the right kind; use a ‘pop cassette’ for best results. The selected program might also be unsuitable, so choose one with a longer washing time. Ensure the door can open automatically at the end of the cycle. Finally, allow sufficient time for the dishes to dry; wait for the signal tone before removing them.
Why is there water under my Daan Tech Bob 2020 Dishwasher (Bob)?
If you see water under your Daan Tech Dishwasher, Bob, it could be due to several reasons. The tank might be flooding. If you're in 'integrated- tank' mode, avoid overfilling it as the capacity is 4 liters. If you're in 'water supply' mode, switch off your water supply. The door could be leaking; check the condition and position of the seals and ensure nothing prevents the door from closing completely. There might be a leak at the drain hose connection; use the supplied clamp and screwdriver to tighten the drain hose on the back of Bob. Or, there could be a leak at Bob’s easywater connection; check the connection and tighten it.
Why my dishes are damaged after using Daan Tech Bob 2020 Dishwasher (Bob)?
If your dishes are getting damaged in your Daan Tech Dishwasher, Bob, it might be due to an unsuitable cycle. Avoid putting any fragile cutlery in Bob.
What to do if Daan Tech Bob 2020 Dishwasher (Bob) is not responsive?
If your Daan Tech Dishwasher, Bob, is not responsive, with a frozen screen and buttons that don't react, try restarting it by unplugging it and then plugging it back in.
Instructions for receiving, unpacking, and safely transporting the Bob dishwasher.
Details on where Bob can be used, including dimensions and placement guidelines.
Steps to connect Bob to water supply and drainage systems, including inlet and outlet.
Guide to initial Bob setup, including language selection, Wi-Fi connection, and account pairing.
Explanation of the automatic door opening mechanism and its usability.
Guidance on arranging the modular basket for optimal loading of dishes.
Overview of Bob's LCD display, buttons, and navigation through menus.
Recommendations for placing kitchenware in the basket for effective washing.
Details on how wash cycles work, including starting, pausing, and cancelling programs.
Information on Bob cassettes and the correct distribution of detergents for optimal results.
Steps to connect Bob to your Daan Tech account for remote management and features.
Details on the Bob+ service, its benefits, and how to activate additional functionalities.
Exploded view of Bob components and general guidance for regular maintenance.
Detailed guide for cleaning Bob's three-stage filter system after each cycle.
Instructions for cleaning the heating disk to prevent clogging and ensure rinsing performance.
Using the Rock'n'Roll cassette for thorough cleaning of Bob's internal components.
Proper methods for cleaning Bob's outer surfaces and display screen.
Steps to remove, wash, and re-insert the spray arm to fix nozzle blockages.
Guide to resolving common problems like Bob not starting or water not draining.
Troubleshooting steps for foam formation and stains inside the tank during wash cycles.
Solutions for dishes not being clean after a cycle, related to placement or detergent.
Troubleshooting steps for issues related to drying performance after a cycle.
Addressing issues related to water leaks and water emerging from under Bob.
Troubleshooting steps for issues when the Bob cassette cannot be inserted or recognized.
Detailed technical data including dimensions, power, water consumption, and energy rating.
Information on the eco-friendly disposal of Bob and its electronic components.
General| Type | Countertop |
|---|---|
| Capacity | 2 place settings |
| Weight | 10.9 kg |
| Energy Consumption | 0.35 kWh per cycle |
| Noise Level | 43 dB |
| Connectivity | Wi-Fi |
To Next Page
