Daan Tech Bob 2020 - 3 | Set-up and Connections

2 available options
3 | set-up and connections
3.1 | Water inlet
Plug the water inlet hose
on one side to the
back of Bob and on the other side to
a water inlet via a 19 mm threaded
end (3/4 inch) and make sure the
connection is firmly tightened.
WARNING: Close the water supply tap
after each use of Bob.
Daan Tech offers
inlet
hoses on its website.
Using Bob as an autonomous free-
standing dishwasher thanks to its
built-in water tank. In this case, no
water inlet hose is needed! Please use
Bob Carafe to quickly fill the water
tank! Bob can be filled with either cold
or hot water up to 60°C.
Please always fill the water tank before use
(4L capacity) until you hear the signal sound
that indicates that the tank is full.
i
i
1
2
Daan Tech offers 3 colours of
.
i
Please scan the QR code
to check it out. .
Please scan the QR
code to check it out.
Do not overfill the tank! If you fill in
more than the water tank capacity (4
L), the excess water will escape into
Bob’s main interior.
5
QUICK SET-UP GUIDE