3.4 | Power plug
Before you connect Bob to the power supply, please make sure that the voltage on
the type plate corresponds to the voltage of your power supply.
The appliance must be placed on an even and stable surface. Daan Tech is not liable
for any damage caused by placing the device on an uneven and/or unstable surface
during use.
WARNING: Please turn the power supply off before installing Bob.
Do not plug or unplug by pulling
the cord, but always pull the
plug directly.
Connect the power cable to Bob’s back.
Connect the power cable to a 220- 240V
50-60Hz plug.
9
QUICK SET-UP GUIDE
To Next Page
Loading...
