Daan Tech Bob 2020 - Bob Casette cannot be inserted.

Issue Possible causes Known solutions
Bob Casette cannot be
inserted.
The safety caps has not yet
been removed.
Remove the safety cap before
inserting Bob cassette (see
page18)
The cassette is inserted
upside down.
Insert Bob cassette with the text
in reading direction.
The inside of Bob cassette’s
lot is blocked.
Do not put anything other than
a Bob cassette in the dedicated
lot.
If you use a detergent other than
Bob cassette, put it directly into
Bob’s main interior
Bob does not recognise
the Bob cassette.
Communication error
between the cassette and
your Bob.
Take the cassette, restart your
Bob and insert it again.
If the problem persists, try
inserting a new Bob cassette.
Bad smell (inside the tank)
Bob has not been used for
a long time.
Drain your Bob completely with
the emptying cycle (Settings
menu), then start an empty
cycle.
Leave the door open at a 10°
angle, if Bob is not in use.
No maintenance cycle has
been run for more then 90
cycles.
Run a maintenance cycle at
least once every 90 cycles with a
rock'n'roll cassette. (see page64)
72
QUICK TROUBLESHOOTING GUIDE