DAB ACTIVE DRIVER M/M 1.1 User Manual

3
Programming
The DAB ACTIVE DRIVER is easy to program, it is essential that key information about the
DUTY POINT and PUMP are know before attempting to program the unit.
>ESSENTIAL INFORMATION
1. DUTY POINT (Pressure)
2. Rated Current of Pump (not required for AD M/M 1.1)
3. Pump Curve
>>Duty Point is the required pressure the system is required to run at. This is inputted in
(Bar).
>>The rated current of the pump can be located on the compliance plate attached to the
pump, or is listed in the DAB Factory catalogue in the ELECTRICAL DATA table.
This is only relevant when using three phase pumps.
>>The Pump Curve is essential to ensure that the duty point is achievable with the pump
selected.
The settings should be recorded in the ACTIVE DRIVER manual for later reference.
It is essential to READ THE MANUAL before attempting to operate the ACTIVE DRIVER.

DAB ACTIVE DRIVER M/M 1.1 Specifications

General

Brand	DAB
Model	ACTIVE DRIVER M/M 1.1
Category	Controller
Language	English