DIGITAL INDICATOR
DN500N
14
6. SET-UP
6-1. SET-UP
●SUMMARY
It is to set F-FUNCTION properly according to the actuator of scale and surroundings so that
the scale can be operated on the optimized condition.
▶ ENTERING SET-UP
When Power is OFF, please keep pressing “3” Key, and then Power will be ON and the main display
will show “TEST”.
Now press “3” Key again and the main display will show “SET. CAL”.
Then press “CLEAR” Key and “F01-XX” will be displayed.
▶ When Power is OFF
① Keep pressing "3" KEY to make Power ON and have “TEST___” displayed.
② Press "3"Key again – “SET. CAL” displayed.
③ Press “CLEAR” Key – “F01-XX” displayed.
※“Χ"is an optional number.
▶ FHOW TO CHANGE FUNCTION NUMBER FOR F-FUNCTION
To change function number of F-Function, you need to press CLEAR Key. Each time you press
it, the function number will be increased.
Function number will be increased from “F01-XX” to “F52-XX” and it returns to “F01-XX”.
If you want to change “F01-XX” to “F30-XX” directly, please ender “30” with number Key and
press “CLEAR.” “F30-XX” will be called right away.
▶ Current Display - “F01-01”
① Press CLEAR Key – “F02-XX”
② Press CLEAR Key again – “F03-XX”
③ Function number is increased continuously each time CLEAR Key is pressed.
▶ To change“F01-XX”to “F80-XX”when current display is F01-XX”
① Press “3” Key – “F01-03”
② Press“2” Key – “F01-32”
③ Press “CLEAR” Key – “F32-XX”
EX
EX
To Next Page
Loading...
