English 31
Anti-tip bracket considerations
Product
Wall
Anti-Tip-Bracket
1. Bracket positioning: follow the cabinet-
specic height table.
2. Screws: Tighten all 3 screws on the
brackets.
3. Push the product up against the rear
wall of the cabinet.
4. Spacer: If using the spacer, you must
follow the positioning specications of
the bracket (see the table above).
CAUTION
• The height of the spacer must be
calculated based on the depth of the
cabinet.
• The spacer must be xed separately
from the cabinet.
• When using the spacer, tighten the
spacer rmly and then tighten the anti-
tip bracket.
When installing the product into the cabinet
Tape or Fixer
Before positioning the product in the
cabinet, plug in the power cord. Then,
attach the power cord near the front of the
cabinet opening using tape or xer such as
clip, pin, etc.
After positioning the product inside the
cabinet, make sure the power cord is
positioned on the top of the product (as
shown in the in the gure).
Dacor_T-TYPE_BRF9000M_IM_DA68-03621F-00_EN.indd 31 2017-09-28 3:10:13
To Next Page
Loading...
Need help?
General
