English 41
13. Aligning the Panel
NOTE
Each custom panel comes with 12 dedicated screws for ne-tuning. Use a minimum
number of screws to ne-tune the custom panel with the cabinet. Once ne-tuning is
complete, x the custom panel with the top nut.
There are two panel-adjustment mechanisms at the top and two at the bottom of the door.
Adjust the panel so it aligns with the surrounding cabinetry.
The gap between the cabinet and the panel must be:
• 1/8” (3 mm) on top
• 1/8” (3 mm) on the side
1/8”
1/8”
1/8”
Top of the Door
1. Use the double-threaded bolts to align the door panel.
2. Engage a side screw (see the graphic) to shift the panel side to side.
3. Engage Screw 1 (see the graphic) to shift the panel forward/backward; engage Screw 2
to set the panel in place.
Dacor_T-TYPE_BRF9000M_IM_DA68-03621F-00_EN.indd 41 2017-09-28 3:10:16
To Next Page
Loading...
Need help?
General
