EasyManua.ls Logo

Dacor EF36LNBSS - Installation Requirements; Tools and Parts; Location Requirements; Opening Dimensions

Dacor EF36LNBSS
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
Location Requirements
Your Dacor refrigerator can be recessed in an opening between
cabinets or installed at the end of a cabinet run using a side panel
to enclose the refrigerator.
IMPORTANT:
Observe all governing codes and ordinances.
It is recommended that you do not install the refrigerator near
an oven, radiator, or other heat source.
Do not install in a location where the temperature will fall
below 55°F (13°C).
Floor must support the refrigerator weight, more than 600 lbs
(272 kg), door panels and contents of the refrigerator.
Ceiling height must allow for side tipping radius. See Tipping
Radius.
Location should permit doors to open fully. See Door Swing
Dimensions.
Location must permit top grille removal. See Opening
Dimensions.
Opening Dimensions
To avoid tipping during use, the solid soffit must be within 1”
(2.5 cm) maximum above the refrigerator. If the solid soffit
is higher than 1” (2.5 cm) or one is not available, then the
refrigerator must be braced.
If the anti-tip boards are needed, they must be attached to the
rear wall studs 80” to 90” (203.2 cm to 228.6 cm) above the
floor. See Install Anti-Tip Boards for more information.
NOTE:Aclearanceof¹⁄2(1.3 cm) must be maintained above
the top grille in order for the top grille to be removed.
Tools and Parts
Tools needed:
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Cordless drill
Drill bits
Two adjustable wrenches
Phillips screwdriver
Small level
Appliance dolly
Torx
®†
T15 and T27 screwdrivers
¹¹⁄ 32nut driver
³⁄ 8”and¹⁄2open end wrenches
Allen wrench (
5
32”)
¹⁄
4and
5
/16socket drivers
Tape measure
Utility knife
PARTS NEEDED:
Six #8 x 3” (7.6 cm) wood screws (longer screws may be
needed).
One or two 2” x 4” x 32” (5.1 cm x 10.2 cm x 81.3 cm) wood
board(s).
Minimum 7 ft (2.1 m) flexible codes approved water supply
line.
EF series models: Dacor handle kit.
IF series models: Consult a qualified cabinetmaker
or carpenter to make the panels. See the Installation
Requirements section for more information.
Installation Requirements
TORX is a registered trademark of Textron Innovations Inc.
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.
1/2” (1.3 cm)

Related product manuals