45
* Check the wire connections in Door Lock Switch * Exchange of Door Lock Switch
[Disassembly]
1. Remove 4 body-fixing screws
2. Remove the detergent and softener containers
3. Remove 2 screws fixing the door hinge
4. Remove 6 cover screws fixing the cover tub
5. Remove 6 screws fixing the cover tub
6. Remove 2 screws fixing the door lock switch
7. Detach the door lock switch and F-PCB
connector
[Assembly]
Re-assemble the parts in the opposite sequence to
disassembly .
2 3 4 5
(No.1 wire unavailable)
PIN
Arranage
ment
Non-
openable
Door
Details Causes Resolution
Power cutoff or forced
shutdown during
operation
The washer is "ON"
without any power
cutoffs.
Others
Water in tub
High
temperature in
tub
Check whether the water level is above the
safety level.
The door is automatically locked to prevent
damage from hot laundry after the spin cycle
is complete.
The door is automatically locked when the
connector, terminal, or solenoid wire gets
disconnected during operation. The following
instructions must apply to inspect defects.
After the "power cutoff" or "forced shutdown" during operation,
"PCB MICOM" is not able to open the door. At least 5 minutes
must pass before the door becomes openable.
Defects and
Errors
Inspection of Defects
and Errors
Error
Mode
To Next Page
Loading...
Need help?
General
