Parts of the Remote
Controller
22
This remote controller is universal; thus, it may be convertible for TV, Video, CTV, etc.
1. (MUTE) : Press this button, and the sound goes off.
Press again, and the sound returns.
2. (POWER) : TV on/off button in Stand-By mode.
3. TV/AV : Each time you press this button, the TV will cycle
through :
TV => AV1 => AV2 => AV3(S-Video) => TV
4. MULTIMEDIA : Each time you press this button, the TV
will cycle through:
COMP => PC => HDMI 1 => HDMI 2 => COMP
5. SLEEP : Sleep Timer setting.
SLEEP TIMER : OFF
=>
15
=>
30
=>
45
=>
60
=> 75 =>
90
=>
105
=>
120
=>
OFF
6. NUMBER : Press the numbers on this board, you can
select PR directly in TV mode.
Note. When the current state is ST-BY, you can turn on
the TV using a digit key. Then, a PROGRAMME is
selected according to digit number.
7. S.EFFECT : Press to use a spatial sound effect.
8. : You can select sound mode in Mono,
Stereo,
Dual1, Dual2, NiCAM STEREO. It works only in TV mode.
9.
: Adjust the volume.
10. : changes channels on your TV.
11. OK : Auto Tuning Start and Manual Tuning Store.
12. STILL : Press this button to freeze the picture.
13. EDIT : Press this button to EDIT mode.
14. SOUND : Not used.
15. LOCK(Child Lock) : This prevents the use of the TV set
without the remote control.
Note :
•This prevents the use of the TV set without the remote
control.
•If the TV set is in Child Lock mode, the LED will cycle through
red/green.
•If the Child Lock is”On”, then the set can only be switched back
on using the remote control.
To Next Page
Loading...
