7. Chassis SL-150 - NVM reset procedure.
a). Please make instructions from point 5 („Chassis SL-150
programming procedure for Genesis IC - PCB part.”) and
then please choose
„Menu -> Commands -> Terminal1 -> NVRAM Fill”
b) New window „Terminal1 NVRAM Fill” should
appears.
c). Please fill form using values:
Address=”0”, Length=”4096”, Value=”0xFF”,
and then press „Execute”
d). If „NVRAM Fill „ procedure successfully finish then
the colour of text window will change to green. As a
summary you will see text „COMMAND
SUCCESSFULLY!!! „.
If command „NVRAM Fill „ failed then the colour of text window will change to red and appear info „Error !!! „.
In that case please try one more time same operation.
After successfully finish NVM reset you need to switch off and on TV-set.
The first startup procedure will be longer because of writing initial values to NVM.
68
Software Install & Upgrade
To Next Page
Loading...
