10
1.Press the ON/OFF button on the remote control to
turn the unit on; the On LED will light on the indoor
unit and “ON” will light in the remote display.
2.Press the MODE button until the Fan indicator
appears in the display.
No allowance setting temperature
3.To select a fan speed, press the FAN SPEED button
until the desired speed appears in the display (see
below).
TO OPERATE ONLY FAN
To operate only the fan so the unit will circulate the air, proceed as follows:
1.Press the ON/OFF button on the remote control to
turn the unit on; the On LED will light on the indoor
unit and “ON” will light in the remote display.
2.Press the MODE button until the Cool indicator
appears in the display.
3.Using the TEMP.
▼ or ▲
buttons, set the desired tem-
perature. The desired temperature can be changed up
to 32°C and down to 18°C.
4.To select the fan speed, press the FAN SPEED button
until the desired speed appears in the display (see
below).
FAN SPEEDS
“AUTO” The fan will automatically select the fan speed.
“” The fan will operate on low speed.
“” The fan will operate on medium speed.
“” The fan will operate on high speed.
“NATURAL” The fan will randomly cycle through the
speeds simulating a cool breeze.
TO SET UNIT TO COOL MODE
To set the unit to cool the room to a desired temperature, follow the procedures below:
FAN SPEEDS
“” The fan will operate on low speed.
“” The fan will operate on medium speed.
“” The fan will operate on high speed.
“NATURAL” The fan will randomly cycle through the speeds
simulating a breeze.
NOTE:
• If “NATURAL” is selected, the NATURAL” indica-
tor on the indoor unit will light.
To Next Page
Loading...
Need help?
General
