14
1.Open the indoor unit’s cover and make sure the
EMERGENCY/REMOTE switch is set to the EMER-
GENCY position.
3.
To turn the unit off, slide the
EMERGENCY/ REMOTE
switch to the REMOTE position.
2.The unit will then turn on and depending on the room
temperature, it will select the cool or dehumidifier
mode, fan speed and fan direction automatically.
EMERGENCY OPERATION
If the remote control is lost, broken or has no batteries, follow the procedures below:
EMERGENCY/REMOTE Switch
EMERGENCY/REMOTE Switch
1.Press the ON/OFF button on the remote control to
turn the unit on; the On LED will light on the indoor
unit and “ON” will light in
the remote display.
2.Press the MODE button until the Heat
indicator appears in the display.
In the heat mode, the fan direction (UP,
DOWN) is further downward than that in
the cool mode for the good circulation.
TO SET UNIT TO HEAT MODE (ONLY DSB-182LH/182LH-R)
To set the unit to heat the room to a desired temperature, follow the procedures below:
FAN SPEEDS
“AUTO” The fan will automatically select the fan
speed.
“” The fan will operate on low speed.
“” The fan will operate on medium speed.
“” The fan will operate on high speed.
“NATURAL” The fan will randomly cycle through the
speeds simulating a cool breeze.
3.Using the TEMP.
▼ or ▲
buttons, set the desired tem-
perature. The desired temperature can be changed up
to 32°C and down to 18°C.
4.To select the fan speed, press the FAN
SPEED button until the desired speed
appears in the display (see below).
NOTE:
When the heating orperation is started, hot air deliv-
ery might be delayed due to warm up period.
To Next Page
Loading...
Need help?
General
