CONTROL PANEL
It has micom sensor.
As the buttons are pressed, the lamps indicating
the selection of you desired washing program will light up.
4. FUNCTION OF THE CONTROL PANEL
11
FUNCTION OF THE CONTROL PANEL
Display
• The “TIME” part lamp indicates the
residual time and the number of
rinsing and spinning times until
wash is over.
• The “COURSE”, “TEMP”, and
“LEVEL” part lamps are turned on
according to the buttons of the
control panel.
Power Switch
• Press this switch to turn the
power ON or OFF.
• After turning off the power,
wait for more than 3
seconds and then turn it on
again.
POWER
Cancel Button
• With this button, you can arbitrarily
choose course by proper
combination with the right three
buttons.
• If you want the washer to operate
differently from presetting time or to
operate separately among the three
stages, you first push this button
and other buttons sequentially.
Start/Hold Button
• Press this button to begin operation
or to stop operation temporarily.
• Operation and temporary stop are
repeated as it is pressed.
Temperature Selection Button
• This button is used to select the
water temperature according to the
clothes being washed.
• Press this button until your desired
temperature indicator light comes
on, and it will repeat following
signs:
COLD
¤A WARM ¤A HOT
Water Level Selector
• This selector is used to
select the washing water
level according to the size of
the wash load.
Wash Selector
• The above three buttons can
be used to bring the three
washing stages under
control.
Course Selection Button
• This button is used to select the
washing course according to the
type of the clothes being washed.
• You can choose one of the eight
courses by pressing this button
until your desired course indicator
light comes on.
To Next Page
Loading...
Need help?
General
