Maintenance Section
-143-
Seat, Hood Latch & Support
Cylinder - Check, Lubricate
1. Check the operation of the seat adjuster rod.
Make sure that the seat slides freely on its
track.
Lightly oil the seat slider tracks if necessary.
2. Push the lever down to raise the hood and seat
assembly (D, G-Series). Pull the latch to raise
the hood and seat assembly (GC Series). Make
certain the support cylinder will hold the hood
open.
(Note: Unlock latch before pulling it - if key
equipped)
Typical Example
3. Lightly oil the hood latch mechanism and the
rod for the hood support cylinder.
To Next Page
Loading...
Need help?
General
