Maintenance Section
-175-
Typical Example
4. Raise the hood and seat assembly.
5. Remove and discard oil filter element.
6. Wipe sealing surface of oil filter element
mounting base. Make sure the entire old gasket
is removed.
7. Before installing a new filter element, apply a
small amount of clean engine oil to the filter
element gasket.
8. Install the new filter element. When the gasket
contacts the base, tighten it 3/4 of a turn more.
Do not over-tighten.
9. Raise the lift truck, remove the blocking and
lower the lift truck.
Typical Example
10. Fill the crankcase. See “Refill Capacities”.
11. Start the engine and allow the oil to fill the filter
and passages.
12. Check for oil leaks.
13. Stop the engine and measure the oil level.
Maintain the oil level between the MAX. and
MIN marks on dip stick.
14. Close hood and seat assembly.
NOTICE
Servicing of the engine oil and oil filter element
will largely affect the engine performance as
well as the engine life.
Engine oil and filter element must be changed
after the first 50 hours.
To Next Page
Loading...
Need help?
General
