Safety Section
-26-
Do not stack or turn on ramps.
Do not attempt to pick-up or deposit a load unless
the lift truck is level. Do not turn on or drive across
an incline.
Do not go over rough terrain. If unavoidable, slow
down.
Cross railroad tracks slowly and diagonally
whenever possible. A railroad crossing can give a
loaded forklift truck a real jolt. For smoother
crossing, cross the railroad diagonally so one wheel
crosses at a time.
Avoid running over loose objects.
Look in the direction of travel. Look out for other
persons or obstructions in your path of travel.
An operator must be in full control of his lift truck at
all times.
Do not drive in forward direction when loads restrict
your visibility. Operate your lift truck in reverse to
improve visibility except when moving up a ramp.
Be careful when operating a lift truck near the edge
of a loading dock or ramp. Maintain a safe distance
from the edge of docks, ramps and platforms.
Always watch tail swing.
The truck can fall over the edge and cause injury or
death.
Do not operate on bridge plates unless they can
support the weight of the truck and load.
Make sure that they are correctly positioned.
Put blocks on the vehicle you enter to keep it from
moving.
To Next Page
Loading...
Need help?
General
