Daewoo Microwave Oven - User Manual

1
Important Safety Information
Microwave Oven
Installation Manual
Introduction
Your Over-the-Range microwave oven comes complete with an installation instruction kit which contains the following three pieces of information
required to install it.
I. This installation instruction booklet,
complete with diagrams on preparing your
cabinets and microwave oven for
installation.
II. The Top Cabinet Template, used to locate
the power cord clearance hole, cabinet
mounting holes and the vertical exhaust
location.
III. Instead of The Wall Mount Template,
Wall Mounting Plate, used to locate the
mounting plate holes and to locate the
horizontal exhaust location.
Please read all of the instructions
thoroughly before installing your
microwave oven.
NOTE:
IT IS RECOMMENDED THAT TWO
PEOPLE INSTALL THIS PRODUCT.
IMPORTANT:
KEEP INSTRUCTIONS FOR LOCAL
ELECTRICAL INSPECTOR’S USE.
Safety Instructions
This product requires a three prong grounded receptacle. The installer must
perform a ground continuity check on the power outlet box before
beginning the installation to insure that the outlet box is properly grounded.
If not properly grounded, or if the outlet box does not meet the electrical
requirements noted, (under ELECTRICAL REQUIREMENTS), a
qualified electrician should be employed to correct any deficiencies.
CAUTION: FOR PERSONAL SAFETY, REMOVE HOUSE FUSE
OR OPEN CIRCUIT BREAKER BEFORE BEGINNING
INSTALLATION TO AVOID SEVERE OR FATAL SHOCK
INJURY. CAUTION:FOR PERSONAL SAFETY, THE
MOUNTING SURFACE MUST BE CAPABLE OF SUPPORTING
THE CABINET LOAD, IN ADDITION TO THE ADDED WEIGHT
OF THIS 85 POUND PRODUCT, PLUS ADDITIONAL OVEN
LOADS OF UP TO 50 POUNDS OR A TOTAL WEIGHT OF 135
POUNDS.
CAUTION: FOR PERSONAL SAFETY THIS PRODUCT
CANNOT BE INSTALLED TO CABINET ARRANGEMENT’S
SUCH AS AN ISLAND OR A PENINSULA. IT MUST BE
MOUNTED TO BOTH A TOP CABINET AND A WALL.
Electrical Requirements
Product rating is 120 volts AC, 60Hertz, 15 amps, and 1600 ~1700 watts.
This product must be connected to a supply circuit of the proper voltage
and frequency. Wire size must conform to the requirements of the National
Electric Code or the prevailing local code for this kilowatt rating. The
power supply cord and plug should be brought to a separate 20ampere
branch circuit single grounded receptacle. The outlet box should be located
near the cord entry point. The outlet box and supply circuit should be
installed by a qualified electrician and conform to the National Electric
Code or the prevailing local code.
Power supply cord
a) A short power-supply cord is provided to reduce the risks resulting from
becoming entangled in or tripping over a longer cord.
b) Longer cord sets or extension cords are available and may be used if
care is exercised in their use.
c) If a long cord or extension cord is used:
1) The marked electrical rating of the cord set or extension cord should
be at least as great as the electrical rating of the appliance.
2) The extension cord must be a grounding type 3-wire cord, and
3) The longer cord should be arranged so that it will not drape over the
counter top or tabletop where it can be pulled on by children or
tripped over unintentionally.
This over-the-range oven was designed for use over ranges no wider
than 30inches. It may be installed over both gas and electric cooking
equipment.
Grounding Instructions
This appliance must be grounded. In the event of an electrical short circuit,
grounding reduces the risk of the electric shock by providing an escape
wire for the electric current. This appliance is equipped with a cord having
a grounding wire with a grounding plug. The plug must be plugged into an
outlet that is properly installed and grounded.
WARNING - Improper use of the grounding can result in a risk of electric
shock.
Consult a qualified electrician or serviceman if the grounding instructions
are not completely understood, or if doubt exists as to whether the
appliance is properly grounded, and either:
1) If it is necessary to use an extension cord, use only a 3-wire extension
cord that has a 3-blade grounding plug, and a 3-slot receptacle that will
accept the plug on the appliance.
The marked rating of the
extension cord shall be equal to
or greater than the electrical
rating of the appliance, or Do not
use an extension cord.
2) If the power supply cord is too
short, have a qualified
electrician or serviceman
install an outlet near the
appliance.
IMPORTANT SAFETY INSTRUCTION
Never operate the oven when it is empty or without the glass turntable.

Summary

Important Safety Information

Introduction to Installation Kit

Overview of the three key components provided for microwave oven installation.

Grounding and Electrical Safety

Details proper grounding techniques and extension cord usage to prevent electric shock.

Electrical Requirements

Specifies voltage, frequency, and circuit requirements for safe and proper operation.

Installation Hardware and Tools

Installation Hardware Components

Lists all included parts such as lag screws, bolts, templates, and filters for installation.

Required Tools for Installation

Identifies necessary tools like screwdrivers, drill bits, and measuring tape for the installation process.

Mounting Space and Clearance

Mounting Space Requirements

Defines minimum vertical and horizontal clearances for cabinet and cooking surface placement.

Wall Construction and Exhaust Ducting

Wall Construction Standards

Specifies wall support requirements and methods for locating studs for secure oven mounting.

Hood Exhaust Duct Guidelines

Covers exhaust connection types, duct sizing, and maximum equivalent duct lengths.

Ventilation System Instructions

Horizontal Ventilation Motor Setup

Step-by-step guide for orienting and installing the blower motor for horizontal exhaust.

Mounting Plate Installation

Wall Template and Setup

Instructions for using the wall template and marking stud locations for the mounting plate.

Drilling and Securing the Plate

Guidance on drilling holes and securing the mounting plate using toggle bolts and lag screws.

Mounting the Microwave Oven

Top Cabinet Preparation

Steps to prepare the top cabinet, including drilling holes for screws and the power cord.

Lifting and Hanging the Oven

Procedure for safely lifting and temporarily hanging the microwave oven onto the mounting plate.

Vertical Ventilation System

Vertical Ventilation Motor Setup

Instructions for orienting and installing the blower motor for vertical exhaust configuration.

Damper Adjustment for Vertical Vent

Guidance on adjusting the damper for proper airflow in a vertical exhaust setup.

Connecting Ductwork and Recirculation

Connecting Ductwork

Steps for extending and sealing the house duct to connect with the exhaust adapter.

Recirculation Ventilation System

Information on installing the charcoal filter for recirculation venting applications.

Installation Checklist

A final check to ensure all installation steps and requirements have been met.

Daewoo Microwave Oven Specifications

General

Brand	Daewoo
Model	Microwave Oven
Category	Microwave Oven
Language	English