1
LF45/55 series Removal and installation
ACCESSORIES
3-3
3.3 REMOVAL AND INSTALLATION, REAR AIR FOILS
Removing rear air foils
1. Remove the attachment nuts of the cab wall
attachment brackets.
2. Carefully detach the rear air foils from the
cab and carefully cut loose any sealant
between the cab and rear air foil.
3. Remove the residual sealant from the roof
and rear air foil.
Installing rear air foils
1. Degrease the rear air foil parts and the cab
at the positions where sealant is to be
applied.
2. Position the rear air foil against the cab and
check that the rear air foil fits the entire cab
wall.
3. Put a plug in the drip channel between the
rear air foil and the cab wall (A).
4. Apply the specified sealant to the
attachment surfaces. See main group
”Technical data”.
5. Fit the rear air foil to the cab wall using the
attachment nuts and tighten the attachment
nuts to the specified tightening torque. See
main group ”Technical data”.
6. Wait until the sealant has set and remove
the plug from the drip channel.
K1 01 420
A
8
ǹ 0210
https://www.truck-manuals.net/
To Next Page
Loading...
Need help?
General
