1
INTERNAL CAB COMPONENTS
Removal and installation LF45/55 series
4-2
4.2 REMOVAL AND INSTALLATION, DASHBOARD PANELS
Note:
Dashboard panel removal and installation is
listed in the correct sequence. To allow each
following panel to be removed, the earlier
specified panels must be removed first.
Removing steering column dashboard panel
1. If necessary, remove the floor mat.
2. Using the steering column setting, move the
steering wheel to its highest possible
position.
3. Remove the attachment bolts (1) and panel
plug (2) and subsequently the steering
column dashboard panel.
K1 01 427
21
Removing the lower dashboard panel on
co-driver’s side
1. Remove the attachment bolts from the
lower dashboard panel on co-driver’s side.
Remove the lower dashboard panel on
co-driver’s side
K1 01 428
Removing the engine tunnel dashboard
panel
1. Remove the attachment bolts (1) and the
panel plugs (2). Remove the engine tunnel
cover panel.
2. Loosen the 12V power supply connector at
the rear.
K1 01 429
21
2
ǹ 0210
https://www.truck-manuals.net/