©
200423 3-29
Inspection and adjustment
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
ΞΦ95 series
5
10. Correct, if necessary, the brake pressure by
moving the rubber sleeve (1) in relation to the
vertical connecting rod. On no account
change the length L of the (horizontal)
control lever.
11. Remove the rubber sleeve (2) and move the
control lever towards maximum load. Check
that the delivery pressure is now allowed
through with little or no reduction.
Note:
The small socket head screw in the centre of the
valve must not be adjusted.
Drive and chas sis
L
R600781
1
2
To Next Page
Loading...
