EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
4-8
©
200423
Removal and installation
5
ΞΦ95 series
Fitting the fuel filter element
1. Replace the cover O-ring.
2. Fit the fuel filter element in the cover
3. Fit the cover with fuel filter element. Tighten
the filter cover to the specified torque. See
"Technical data".
4. Pump for approximately 1 minute using the
primer pump to partially fill the filter housing
with fuel.
5. Start the engine and run it at idling speed for
a few minutes; this will allow any air in the
filter housing to escape.
6. If the motor will not start up or runs very
erratically, the fuel system must be bled, see
"Draining and filling".
7. Check the fuel system for leaks.
i 400445
To Next Page
Loading...
