Configuration Guide
30. Then we choose the ”No
mask feature and enable the
settings, and we can choose to
set a ”buzzer” to trigger when
there is an alarm for person
with no mask detected.
Click ”Save
31. Testing the function by
walking through without a
mask ensures that the function
works as shown in the right
side and top of the main
window.
27. Click ”exit” in the top left
corner
and it is time to test the
solution now.
Walk through the
measurement zone and verify.
28. From the test we can see
that it measures and detects
well, in the main window top
we see the overview of
measurements and right side
the live results.
29. We can also setup a No
mask alarm by going in to the
same menu clicking the ”Gear”
right top. And choosing ”Event”
Now we will choose our ”visual
channel” and enabling face
detection.
Click ”Save
32. The Blackbody is a little off
so it should be adjusted slightly
in the. Event/ Thermal sensor /
BodyTempDetect/ Blackbody
Click ”Save”
23
To Next Page
Loading...