User’s Manual
130
Click Add.
The device is added into the Added Device area.
You can also double-click the device to add it into the Added Device area.
You can add devices in batches.
5.6.1.3 Adding Remote Devices Manually
On the Add Camera interface, click Manual Add.
Manual add
Configure the settings for the manual adding device parameters.
Table 5-31 Parameters for manually adding device
Channel
In the
list, select the channel that you want use on the Device to
connect the remote device.
Manufacturer In the
list, select the manufacturer of the remote device.
IP Address
In the
box, enter the IP address of remote device.
The default is 192.168.0.0 which the system cannot connect to.
RTSP Port
The default value setting is 554. You can enter the value according to your
actual situation.
HTTP Port
The default value setting is 80. You can enter the value according to your
actual situation.
If you enter other value, for example, 70, and then you should enter 70 after
the IP address when logging in to the Device by browser.
TCP Port
The default value setting is 37777. You can enter the value according to your
actual situation.
User Name Enter the user name of the remote device.
To Next Page
Loading...
Need help?
General
