User’s Manual
7
Parameter Description
Keypad Lock Status
Set the number of attempts to enter the wrong passcode and
lock time for the keypad.
●
Enable the keypad lock function first.
●
For the number of attempts to enter the wrong passcode
w
ithin 30 minutes, you can select from 3 to 10 times. 5 is set
by default.
●
For the lock time, you can select from 3, 5, 10, 20, 30, 60,
90
an
d 180 minutes. 3 minutes is set by default.
No Passcode Arming
Set whether you can use the keypad to arm the system without
passcode. Disable by default.
Enable
No Passcode Arming
function does not meet EN50131-
1 certifications.
Transmit Power
Select from high, low, and automatic.
The higher transmission power levels are, the further
transmissions can travel, but power consumption increases.
If you select
Low
, the keypad will enter into reduced sensitivity
mode.
Card Reader Config
Enable card reader function and soft encryption function on the
keypad.
●
Card Reader
: Enable by default. If enabled, the keypad
supports card recognition function. If disabled, the card
reader function will be turned off.
●
Soft Encryption
: Enable by default. If enabled, card
information will be encrypted when issuing the card.
Backlight Brightness
Adjust backlit keypad brightness. You can select from
Off
,
Low
and
High
.
When battery level is low, the backlight brightness will turn to
Low
automatically.
Buzzer Volume
Configure volume level of the buzzer. Select from
Off
,
Low
, and
High
.
Signal Strength Detection
Test the current signal strength.
Signal strength test is not supported when the keypad is in the
sleep mode. You can press any key to wake up the keypad.
Cloud Update Update online.
Delete
Delete the keypad.
Go to the hub screen, select the keypad from the accessory list,
and then swipe left to delete it.