User’s Manual
12
To arm the system without a passcode, you can enable the
No Passcode Arming
function first,
and then press and hold or .
●
To arm a single room, you can enter the relevant arming command.
◇
If the arming is successful, the arming and disarming indicator light will flash blue 3 times
slowly, and then will remain solid, with one short beep.
◇
If the arming fails because of the potential faults, the arming and disarming indicator light will
flash green twice quickly, and then it will go back to the normal status, with one long beep.
And if you enter the same arming command again within 30 seconds, or swipe the same card
again within 10 seconds, you can force arm the room.
◇
If arming fails because of reasons such as using the wrong passcode or invalid card, or
allowing people with no permission to use the keypad, the backlit light will flash twice quickly
with one long beep.
By swiping the card, you can only use global away arming.
8.4 Disarming
●
If global disarming is successful, the arming and disarming indicator light will flash green 3 times
slowly, and then turn off, with 2 short beeps.
After successfully disarming the system, if there are system faults, the fault indicator light will
flash yellow slowly.
●
If disarming for a single room is successful, the arming and disarming indicator light will slowly
flash green 3 times, and then it will go back to the normal status, with 2 short beeps.
●
If disarming fails because of reasons such as using the wrong passcode or invalid card, or
allowing people with no permission to use the keypad, the backlit light will flash twice quickly
with one long beep.
◇
If one or more rooms associated with the card are in the arming status, then all the associated
rooms will be disarmed if you swipe the card.
◇
If all the rooms associated with the card are in the disarming status, then all the associated
rooms will be armed if you swipe the card.
8.5 Searching for the Room Status
You are only allowed to search for the status of a single room.
●
If your search is successful, the keypad will beep once, and indicator lights will show the room
status.