User’s Manual
2
4 Adding the Keypad to the Hub
Before you connect it to the hub, install the DMSS app to your phone. This manual uses iOS as an
example.
●
Make sure that the version of the DMSS app is 1.98 or later, and the hub is
V1.001.0000000.8.R.220319 or later.
●
Make sure that the hub has a stable internet connection.
●
Make sure that the hub is disarmed.
Step 1 Go to the hub screen, and then tap to add the keypad.
Step 2 Tap to scan the QR code at the bottom of the keypad, and then tap
Next
.
Step 3 Tap
Next
after the keypad has been found.
Step 4 Follow the on-screen instructions and switch the keypad to on, and then tap
Next
.
Step 5 Wait for the pairing.
Step 6 Customize the name of the keypad, and select the area, and then tap
Completed
.
To Next Page
Loading...
Need help?
General