User's Manual
151
To use this function, make sure the email function is enabled in
Main
Menu > NETWORK > EMAIL
.
Record Channel
Select the channel(s) that you want to record. The selected channel(s)
starts recording after an alarm event occurs.
The recording for intelligence event and auto recording function must
be enabled. For details, see "5.1.4.9 Configuring Recorded Video Storage
Schedule" and "5.9.1 Enabling Record Control."
PTZ
Click
to display the PTZ interface.
Enable PTZ activation function. For each PTZ camera, select the preset
that you want to be called when an alarm event occurs.
Motion Detect can only activate PTZ preset.
Post Record
Set a length of time for the Device to delay turning off recording after
the alarm is cancelled. The value ranges from 10 seconds to 300
seconds, and the default value is 10 seconds.
Tour
Select the
check box to enable a tour of the selected channels.
To use this function, make sure the tour is enabled and configured in
Main Menu > DISPLAY > TOUR
.
Snapshot
Select the
check box to take a snapshot of the selected
channel.
To use this function, make sure the following settings are configured:
The snapshot function is enabled for motion detect alarms in
Main
Menu > STORAGE > SCHEDULE > Snapshot
.
Select
Main Menu > CAMERA > Snapshot
, in the
list, select
.
Video Matrix
Select the check box to enable the function. When an alarm event
occurs, the video output port outputs the settings configured in "
Main
Menu > Display > Tour
."
Not all models support this function.
Buzzer Select the check box to activate a buzzer noise at the Device.
Log Select the check box to enable the Device to record a local alarm log.
Voice Prompts
Select to enable audio broadcast/voice prompts in response to a
motion detection event.
Click Apply to save the settings.
The INTELL SETTING interface is displayed.
Select the Enable check box, and then click Apply.
The tripwire detecting function is active. When the target object crosses the tripwire in the
defined direction, the system activates alarms.
To Next Page
Loading...
Need help?
General
